International WoodGas Forum

Hi forum

I started with grinding valve seats on engine and installing the spark plugs.
Regards
Johan

Hey Johan
Did you drilled the holes by hand?
it looks like they are not all in the same position ?

regards Pascal

Johan,

Very intresting and impressive work you are doing.

Thank you for sharing!!

Luk

Hey Pascal

Yes by hand
I re drilled the old injector holes from 8mm to 12.5mm and cut tread by hand 14X1.25, injector and now spark plugs are closer to intake valves that way it looks off ,picture goes like this ,,, intake ,,exhaust ,,,exhaust ,,, intake ,,exhaust,,intake

Regards
Johan

luk hat geschrieben:Johan,

Very intresting and impressive work you are doing.

Thank you for sharing!!

Luk

Thanks Luk

Hi Johan
Really good work.
I'm looking forward to the first test run.
Which ignition system you will equip the motor?
And how is the ignition sequence terminated ?

regards Pascal

Hi Pascal

For start i will use automotive ignition system (from any 6 cylinder engine) in my case from Lexus GS 300
later will convert to six coil home built or proper industrial ignition Altronic cd series or simular. Lexus 6 cylinder , distributor , coil, igniter (ignition module)..

Regards Johan

Hi forum
Finished with engine conversion to spark plug ignition , here some photos Hope for test run next weekend

Regards Johan

Johan.....
.....that's incredible

i get crazy how the engine looks.

Very good work !

How did you puts the engine back in this state?
Hope it will run really well!
He does look like a winner already.



regards Pascal

Hi forum

Finished with exhaust manifold insulation

[img][/img]