International WoodGas Forum

Hello Johan,

very nice project!

you can a induction generator directly connect to Net if the engine run, better he run first as a E- motor and you sycronisize with a clutch.

this I have not found in englisch:

http://de.wikipedia.org/wiki/Asynchrong ... zanbindung

good luck René

Hi forum
This is some photos of the parts that i built for my 100Kwe gasifier project ash remuving arms mehanism ash extraction hole stil not cut

Stainles stil mesh side grate with cone in the midle

Gasifier fire tube whit spiral air lines f33mm 7 pieces

Reduction bell 10cm deep , part of nozzles , and heart 210mm.
body is old water heater

this is the outer body ...from old beer barels
I extend the barel vas too short

Ökostromer hat geschrieben:Hello Johan,

very nice project!

you can a induction generator directly connect to Net if the engine run, better he run first as a E- motor and you sycronisize with a clutch.

this I have not found in englisch:

http://de.wikipedia.org/wiki/Asynchrong ... zanbindung

good luck René

Thanks for the info René

Hey Johan

Looks really good.
Hope it works as it should. APL has so far always just announced a 100kW gasifier. But it was as far as I know never built.
I wish your system will work well.

How did you cool your gas?

And what´s your filter material ?

regards Pascal

Pascal Kirchner hat geschrieben:Hey Johan

Looks really good.
Hope it works as it should. APL has so far always just announced a 100kW gasifier. But it was as far as I know never built.
I wish your system will work well.

How did you cool your gas?

And what´s your filter material ?

regards Pascal

Hi Pascal

I hope it will work nice if not i haw nice sledgehammer
For cooling and cleaning the gas i haw some idea for wegtable oil cleaner cooler system ...check the photo

Regards Johan