100 Kwe Gasifier project

[Johan]

Hi forum

I started with grinding valve seats on engine and installing the spark plugs.

IMG_20150227_155941.jpg

IMG_20150223_160608.jpg

IMG_20150223_160527.jpg

Regards
Johan

[Pascal Kirchner]

Hey Johan
Did you drilled the holes by hand?
it looks like they are not all in the same position ?

regards Pascal

[luk]

Johan,

Very intresting and impressive work you are doing.

Thank you for sharing!!

Luk

[Johan]

Hey Pascal

Yes by hand
I re drilled the old injector holes from 8mm to 12.5mm and cut tread by hand 14X1.25, injector and now spark plugs are closer to intake valves that way it looks off ,picture goes like this ,,, intake ,,exhaust ,,,exhaust ,,, intake ,,exhaust,,intake

Regards
Johan

[Johan]

Johan,

Very intresting and impressive work you are doing.

Thank you for sharing!!

Luk

Thanks Luk

[Pascal Kirchner]

Hi Johan
Really good work.
I'm looking forward to the first test run.
Which ignition system you will equip the motor?
And how is the ignition sequence terminated ?

regards Pascal

[Johan]

Hi Pascal

For start i will use automotive ignition system (from any 6 cylinder engine) in my case from Lexus GS 300
later will convert to six coil home built or proper industrial ignition Altronic cd series or simular.

IMG_20150302_105136.jpg

Lexus 6 cylinder , distributor , coil, igniter (ignition module)..

Regards Johan

[Johan]

Hi forum
Finished with engine conversion to spark plug ignition , here some photos

IMG_20150324_121732.jpg

IMG_20150324_121801.jpg

IMG_20150324_121747.jpg

IMG_20150324_121814.jpg

Hope for test run next weekend

Regards Johan

[Pascal Kirchner]

Johan.....
.....that's incredible

i get crazy how the engine looks.

Very good work !

How did you puts the engine back in this state?
Hope it will run really well!
He does look like a winner already.



regards Pascal

[Johan]

Hi forum

Finished with exhaust manifold insulation

[img]

IMG_20150518_182702.jpg

[/img]